Tips about Ford Diagnostic Scanner IDS Ford PCM reprogramming:

V105 is the latest wifi connection Ford Diagnostic Scanner .IDS Ford support diagnose and reprogramming.OBD2repair.com share you inportant tips on PCM reprogramming with Ford Diagnostic Scanner IDS Ford.

Ford Diagnostic Scanner IDS Ford with IDS Ford Software V105

Ford Diagnostic Scanner IDS Ford Error Code:11.0×0 851082 when PCM reprogramming

It’s aimed to help how to reprogram/reflash Ford PCM via IDS Ford software esp. for those with Error Code:11.0×0 851082 will be shared here by other users.

Error message:

“The operation cannot begin because the PCM failed to complete a service procedure. Perform PMI on the PCM to resolve the issue.”

Possible scanners working with:

VXDIAG VCX NANO Ford

Ford Diagnostic Scanner IDS Ford Clone

Customer solutions:

Customer A:

Turnoff your firewall

Customer B:

Uninstall fmp and reinstall it. I have had this happen before.
I have had some new pcm be un programmable.
And just for reference. Fmp doesn’t like Google. Use 32 bit processor as well.
I had to slow my computer down from 64-32 because fmp would not work correctly with 64.
Good luck.

Customer C:

If you are checking PCM for up-dates, Ford will advise on 6.0L powertrain if there is a reflash avail for TCM, FICM or PCM, if it states there is no update then all three modules are at latest level, no action required, I am aware it states to remove FICM relay prior to reflash FICM, this is a carryover note from when we used PDS or WDS to reflash the FICM, if you are using IDS Ford with VMM interface its not required to remove the FICM relay, I have reflashed over 1000 of them this way over the last 7 years, as always make sure the battery stays in the sweet spot @ 13.5 volts, make sure your laptop has sufficient power, I always plug in, make sure cables to veh and laptop are safe from accidental disconnect, Good luck!

Customer D:

If you try to Ford Diagnostic Scanner IDS Ford genuine or clone to make reprogaming well you need IDS Ford V98.01 or higher.

It would be good to check if during initiation programming interface output 18,5V on pin 13 in OBD connector.

More detail about Ford Diagnostic Scanner IDS Ford,pls connect

Website:www.obd2repair.com
Skype：obd2repair / eobdscan1
We Chat/ Whatsapp (+86)13728823163
Email: info@obd2repair.com